KA:Nsg

From Kirby Speedrunning Wiki
Jump to navigationJump to search

Languages: English 日本語

Any% No Stone Glitch is the least difficult category to complete. World Record tends to give the impression that it is very difficult because of the large number of techniques with one frame of grace, but most of these do not need to be used unless you are aiming for the World Record. The important thing is to operate UFOs accurately and handle enemies. Let's learn them little by little.

This page contains only the minimum skills and techniques that must be learned to complete this category. If you want to improve your time further, please refer to this guide.

1-1

First, clear the area as normal. There is no need to use the copy ability. After clearing the area, enter 1-1 again and execute the UFO carryover bug. There is an enemy that can copy UFOs in the hidden room in the waterfall.
KA NSG 1-1-1.png
After copying the UFO, activate the Pause Carryover (see link for how to do this).

2-3

I recommend using the pause bug. Usually you have to do it several times to succeed, but it is still well worth it. If you do not use the pause bug, you will need to activate the UFO carryover bug again after clearing the area because you will not be able to move on without discarding the UFO.

After breaking the bomb block, move as shown in the image. At this time, be careful not to scroll the screen down too far.
KA NSG 2-3-1.png 2-3-2.png
Pause while moving down. If it fails, start over from the original position.
KA NSG 2-3-3.png
If you take damage while pausing, move up. If the top and bottom edges of the screen bug you, you have moved.
KA NSG 2-3-4.png
When you release the pause, you are inside the wall. Continue to the tobira in the upper right corner.
KA NSG 2-3-5.png

3-3

Discard the UFO and proceed. After clearing, take the UFO at 3-2. After copying, activate the pause carryover. Leave the mix from the two Rockies at 3-2 to confirm the UFO.
3-2 ufomix.gif
If you fail, go down and try again.

5-2

Here, as in 2-3, I recommend using the pause bug. If you do not use the pause bug, you will have to proceed through a complicated and intricate stage.

Dump the UFO and proceed. Immediately after entering the room in the image, make a big jump to the right and pause at the position in the image. If it fails, enter the room and start over.
KA NSG 5-2-1.png
If you take damage, you can enter the tobira by entering above. After clearing, leave a mix from 2 Rockies at 5-1 to confirm UFO. Activate the pause carryover.
5-1 ufomix.gif
The trick is to slide just at the edge of the scaffold. If you fail, deliberately fall and start over.

5-4

In the battle against the Meta Knights, you must annihilate the enemies below, then one level up, and finally the enemies on the top level by only half a square head. Note that once you get to the upper level, you will not be able to go down as a UFO. On the next map, go ahead through the hidden tobira at the waterfall on the way.

7-2

If you advance through the hidden tobira above the regular tobira, the number of mid-bosses will be reduced from seven to four, but instead the mid-bosses will move faster. If you are in a UFO state, you will not have much difficulty.

7-5

Be sure to defeat the flamers circling the scaffold before proceeding. If you try to advance forcibly, you will be dropped into the abyss at a high rate.

List of recoveries for lost UFOs

  • Copy Eufor in the hidden room at 1-1 (see above).
  • Copy UFO in the hidden room at 2-3.
  • Mix and leave from 2 Rockies in 3-2 to confirm UFO (see above).
  • Copy Eufor at 4-1.
  • Mix from 2 Rockies at 5-1 and leave to confirm UFO (see above).
  • Copy Eufor on 6-6.

Tips

  • Eufor, the enemy, will be restored when you reset or go to a different level.
  • When you want to recover, you can recover all your money by defeating the middle boss in the arena. You can also recover by playing mini-games.
  • If you want to recover without UFOs, you can quickly recover all the UFOs by resetting the game immediately after clearing the stage.
  • To reset, press and hold A+B+Start+Select at the same time.